Load data for .30 PICRA + .308 | 170gr | Speer Deep Curl Flat Points

Recommended Powder(s):

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.308 \| 170gr \| Speer Deep Curl Flat Points
Manufacturer SKU:	2042
Bullet Weight:	170gr \| 11.0g
Bullet Diameter:	0.308" \| 7.82mm
Bullet Length:	<<locked>>
Caliber:	.30 PICRA load data
Case Length (l3):	1.291" \| 32.8mm
Cartridge Length (C.O.L.):	<<locked>>
Seated Depth:	<<locked>>
Shank Seated Depth:	<<locked>>
Case Capacity:	24.2 Grains of Water \| 1.57 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	40611 psi \| 2800 bar
LID:	LID_B6164_C311
Last updated:	2026-01-21

Load data for 42 loads in caliber .30 PICRA with .308 | 170gr | Speer Deep Curl Flat Points bullet and 21 powder(s). The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	72%	36201	89%	**78	100%
ADI APS 350	<<locked>>	62%	36027	89%	**8	100%
ADI APS 450	<<locked>>	64%	36506	90%	**1	100%
Accurate 4100	<<locked>>	73%	36506	90%	**73	93%
[Accurate No. 11 FS]*	<<locked>>	81%	36245	89%	**80	86%
Alliant 2400	<<locked>>	69%	36042	89%	**63	95%
Alliant BLUE DOT	<<locked>>	72%	36274	89%	**43	99%
Baschieri & Pellagri 102 Pistol	<<locked>>	74%	36260	89%	**17	100%
Hodgdon H110	<<locked>>	77%	35795	88%	**89	90%
Hodgdon LilGun	<<locked>>	77%	35636	88%	**09	96%
Maxam CSB 1	<<locked>>	63%	35520	87%	**37	100%
Ramshot Enforcer	<<locked>>	69%	36201	89%	**73	96%
ReloadSwiss RS 30	<<locked>>	93%	35839	88%	**16	93%
SNPE Vectan BA6 1/2	<<locked>>	95%	35984	89%	**66	98%
SNPE Vectan BA7 1/2	<<locked>>	67%	36390	90%	**35	100%
[Somchem S265]*	<<locked>>	85%	36143	89%	**47	88%
Vihtavuori 3N38	<<locked>>	69%	36521	90%	**17	100%
Vihtavuori N105	<<locked>>	71%	36535	90%	**30	100%
Vihtavuori N110	<<locked>>	85%	35563	88%	**73	96%
Vihtavuori N32C Tin Star	<<locked>>	79%	36230	89%	**1	100%
[Winchester 296]*	<<locked>>	76%	36448	90%	**09	86%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	26585	65%	**50	100%
ADI APS 350	<<locked>>	60%	34534	85%	**2	100%
ADI APS 450	<<locked>>	60%	33924	84%	**5	100%
[Accurate 4100]*	<<locked>>	61%	24598	61%	**83	86%
[Accurate No. 11 FS]*	<<locked>>	73%	27499	68%	**45	81%
Alliant 2400	<<locked>>	61%	27586	68%	**32	91%
Alliant BLUE DOT	<<locked>>	61%	26600	66%	**93	97%
Baschieri & Pellagri 102 Pistol	<<locked>>	62%	27311	67%	**9	100%
[Hodgdon H110]*	<<locked>>	63%	22698	56%	**66	81%
[Hodgdon LilGun]*	<<locked>>	61%	20262	50%	**53	85%
Maxam CSB 1	<<locked>>	60%	33040	81%	**07	100%
Ramshot Enforcer	<<locked>>	61%	26977	66%	**32	92%
[ReloadSwiss RS 30]*	<<locked>>	73%	20653	51%	**33	80%
[SNPE Vectan BA6 1/2]*	<<locked>>	66%	16491	41%	**2	85%
SNPE Vectan BA7 1/2	<<locked>>	61%	30850	76%	**70	100%
[Somchem S265]*	<<locked>>	69%	23728	58%	**47	81%
Vihtavuori 3N38	<<locked>>	61%	29167	72%	**19	100%
Vihtavuori N105	<<locked>>	61%	26527	65%	**96	100%
[Vihtavuori N110]*	<<locked>>	61%	16824	41%	**8	82%
Vihtavuori N32C Tin Star	<<locked>>	74%	32692	81%	**5	100%
[Winchester 296]*	<<locked>>	67%	26760	66%	**61	80%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data